Epson NX300 Mode D'Emploi

Problems and Solutions

2. The message on the display screen asks if the 

paper has been removed. Press 

1

 to clear the 

message.

3. Close the ADF cover and reload the paper.

■

Make sure the recipient’s fax machine is turned on and working.

■

Make sure the 

LINE

 port on the NX300 Series is connected to a telephone 

wall jack. Verify that the telephone wall jack works by connecting a phone to 
it.

■

If the line has static, press 

Setup

, select 

Fax Settings

, select 

Communication

, and turn off the 

V.34

 and 

ECM

 (Error Correction Mode) 

settings.

■

If the NX300 Series is connected to a DSL phone line, you must have a DSL 
filter connected to the phone jack. Contact your DSL provider for the 
necessary filter.

■

If you answer the phone and hear a fax tone and the call disconnects when you 
hang up, make sure there is a phone or answering machine connected to the 
EXT. port on the NX300 Series.

■

For the best print quality, use Epson papers (see page 6) and genuine Epson 
ink cartridges (see page 38).

■

If you notice light or dark bands across your printouts or they are too faint, 
run a nozzle check (see page 34) to see if the print head needs cleaning.

■

If you notice jagged vertical lines, you may need to align the print head. See 
the on-screen Epson Information Center for instructions.

■

The ink cartridges may be low on ink. Check your cartridge status (see 
page 34) and replace cartridges, if necessary (see page 38).

■

If you’re copying, place the document flat against the scanner glass. 

■

Clean the scanner glass with a soft, dry, lint-free cloth (paper towels are not 
recommended), or use a small amount of glass cleaner on a soft cloth, if 
necessary. Do not spray glass cleaner directly on the glass.