Epson 320 Manuel D’Utilisation

Problems and Solutions

Make sure the printer driver was installed correctly and that your computer’s 
TCP/IP settings are configured correctly. 

■

Make sure the product is turned on and the 

WiFi

 light on the product is on.

■

When using TCP/IP, make sure the product’s IP address is set correctly for 
your network. If your network does not assign IP addresses using DHCP, you 
need to set the IP address manually.

Print a Network Status Sheet (see below) and check the signal strength. If it’s poor, 
try moving the product closer to your wireless router or access point. Avoid 
placing the product next to a microwave oven, 2.4 GHz cordless phone, or large 
metal objects such as a filing cabinet.

■

Epson Scan is not available in Mac OS X 10.6; see page 21 for scanning 
instructions.

■

If network communication was interrupted while starting Epson Scan, exit 
Epson Scan, and restart it after a few seconds. If Epson Scan cannot restart, 
turn the product off and on, and then try again. Check the 

Timeout Setting

 

in 

EPSON Scan Settings

. For details, see the Epson Scan Help.

■

If you are scanning a large document at high resolution, a communication 
error may occur. If the scan did not complete, lower the resolution.

1. Press the x

Menu

 button.

2. Press u or  d to select 

Network Settings

, then press 

OK

.

3. Press u or  d to select 

Print Network Status Sheet.

4. Press the x

Color

 button to print a network status sheet.