Epson 1000 Brochure
EPSON AMERICA INC.
EPSON
Product Support Bulletin
Subject: New ActionLaser 1000/1500 Imaging Cartridge Replacement Procedure
Date: 6/4/93
PSB No: P-0100
Page(s): 1 of 2
Originator: LHT
This bulletin provides supplemental information to resolve a situation when printed
images become faint, SelecType Level 2 TONER message indicating that the
toner amount is low (E*
F), and three messages flash in rotation on the LCD:
NEW CARTRIDGE?
YES, PRESS RESET
NO, PRESS CONTINUE.
NO, PRESS CONTINUE.
After the instructions to replace the imaging cartridge (as shown on pages 3-29
through 3-32 of the ActionLaser 1000/1500 Reference Guide) has been followed,
some printers may continue to display the above messages.
through 3-32 of the ActionLaser 1000/1500 Reference Guide) has been followed,
some printers may continue to display the above messages.
This condition does
not affect printer operation or print quality in any way.
It can be corrected by
resetting the printer as described below:
NOTE:
Resetting clears all the saved SelecType information but the status
sheet printed in step 3 shows the current settings.
sheet printed in step 3 shows the current settings.
1. Press the LEVEL 1 button to enter SelecType Level 1.
2. Press CONTINUE
button until STATUS SHEET appears on the display.
3. Press INITIALIZE RESET
button twice to print a status sheet.
4. Save the status sheet for future reference, then turn off the printer.
5. Press and hold down the ON LINE, CONTINUE
and FEED
buttons
while you turn on the printer and keep pressing the buttons until the following
message appears:
message appears:
STARTUP ERROR LT<>A4
When the above message appears, release the buttons.