Epson 3250 Produit Fiche De Donnée

ActionPrinter 3250

Make sure the printer is turned off and

paper is loaded.

the narrow cover from the

printer.

default settings

hold 

button while you turn on the
printer.

The printer prints a series of questions about your printer

Press the 

YES and 

buttons to respond and make

changes. All new settings remain in effect until you

change them again.

 

Note:

Turn off the printer at any time to exit the default settings 

then

replace the narrow cover.

You can change the printer settings listed here:

Character table

437,850,860,863,865

Page length

11", 12", 8.5", 70/6"

Skip over perforation

on. on

Tear-off position

On cutter.  Above cutter

TOF position

-3, -2, -1, +0, +1, +2, +3

Graphic print direction

Download

Auto line feed

Hex dumo. Demonstration

You can print a self test to make sure your printer operates properly.

1. Make sure 

printer is turned off and paper is loaded.

2. Hold down the 

FORM FEED button while you turn on the

printer. It loads a 

paper automatically and begins

to print characters in the current font and character table.

FF

3. To stop the self test, turn off the printer.

Most application programs let you specify the type of printer you

use so that the program can take full advantage of the printer’s
features. Many programs provide an installation or setup m&u that
presents a list of printers.

To take full 

advantage at your printer’s features, including ESC/P2,

choose one of the first three printers on the list below. If none of
these is listed, contact your software manufacturer for an update
that includes one of the three. Until you receive an update, choose
another printer as close to the top of the list as possible.

LQ-100
LQ-570

1

E S C / P 2

LQ870

LQ-510/550
LQ-860

LQ-850

LQ-200
LQ-500
LQ-2550
LQ-2500

LQ-800
LQ-1500

If none of these printers is listed among your program’s options,
select the first available of the following: EX, FX, LX, RX, MX, Epson

printer, Standard printer, Draft printer. Because these are 9-pin
printers, however, your graphics printing may not be correct.

You can load standard-sized single sheets with the paper cassette

and you can load single sheets of paper from 

148 mm (5.8 inches) to

257 mm (10.1 inches) wide with the manual insertion slot.

The tips below help you get the best performance when printing with

the cassette.

.

Load paper in the paper cassette before you turn on the printer

and send data. When the printer receives data from the

computer, it loads a single sheet automatically and begins to

print.

l

If the printer runs out of paper during a print job, reload the

paper cassette and press the FORM FEED button to load the
paper.

l

Press the FORM FEED button to eject a sheet of loaded paper.

You 

can adjust the top-of-form position with the gear under

printer cover. It is marked by + and -signs. Open the

printer cover and turn the gear to adjust the position. The
notches on the ribbon mask indicate the base line of printed
characters. The gear adjustment affects 

loaded page. If

you want to change the top-of-form position permanently, you

can adjust it in the default-setting mode. However, most
application software programs take care of the top and bottom
margins. You usually don’t need to set 

top-of-form position

on the printer.

ribbon mask

--- base line of 

24-Pin Printers