Epson wf-7010 Guide D’Installation Rapide
Start Here
5
Replace the cover and gently insert the paper cassette.
6
Extend the output tray and raise the stopper as shown.
(If you are loading legal-size or A3 paper, do not raise
the stopper.)
(If you are loading legal-size or A3 paper, do not raise
the stopper.)
5
Choose your connection
You can connect your printer to your existing network using
an Ethernet
an Ethernet
®
cable, or directly to your computer using a USB
cable. See below for details on each connection method.
Note:
Do not connect the printer to your computer until you’re
instructed to do so.
Direct USB connection
Make sure you have a USB cable. (Not included.)
Wired Ethernet connection
Make sure you have an Ethernet network cable. (Not included.)
You must install the software on every computer from which
you want to print.
You must install the software on every computer from which
you want to print.
6
Install software
Note:
If your computer does not have a CD drive, you can
download the software from the Epson website, as described
under “Epson technical support.”
under “Epson technical support.”
1
Make sure the printer is
NOT CONNECTED to your
computer.
Windows
®
:
If you see a Found New Hardware screen, click
Cancel and disconnect the USB cable. You can’t install your
software that way.
software that way.
Read these instructions before using your printer.
1
Unpack
Caution:
Do not open ink cartridge packages until you are ready to
install the ink. Cartridges are vacuum packed to maintain reliability.
Remove all tape and protective materials, including the foam and
plastic inside the printer.
plastic inside the printer.
2
Turn on
1
Connect the power cord.
Caution:
Do not connect to your computer yet.
2
Press the
power button.
3
Install ink cartridges
1
Open the printer cover and cartridge cover.
2
Shake each cartridge as shown for about 5 seconds and
remove from package.
remove from package.
3
Install each cartridge in the correct slot for its color.
Push each cartridge in until it clicks.
Push each cartridge in until it clicks.
4
Close the printer cover and the cartridge cover.
The printer starts priming the ink. This takes about 5 minutes.
When the green
When the green
power light stops flashing, priming is
complete.
Caution:
Don’t turn off the printer or open the cover while it is
priming or you’ll waste ink.
Note:
Your printer ships with full cartridges and part of the ink from
the first cartridges is used for primming the printer.
4
Load paper in the cassette
You can load letter-, A4-, or legal-size paper in the cassette.
For instructions on loading envelopes and using the rear tray,
see the online User’s Guide.
For instructions on loading envelopes and using the rear tray,
see the online User’s Guide.
1
Pull out a paper cassette, and remove the cover.
2
Slide the edge guides outward.
Note:
Before loading legal or A3 paper, extend the cassette as
shown.
3
Insert the paper with the glossy or printable side face down.
4
Slide the edge guides against the paper, but not too
tight. Make sure the paper is under the tabs on the edge
guides.
tight. Make sure the paper is under the tabs on the edge
guides.
*412102600*
*412102600*
WorkForce
®
WF-7010