Epson MG-850HD Manuel D’Utilisation

Using the Projector Security Features

To change your password:

1. Use the remote control to select

Password

and press the enter button.

Note: The default password is “0000”.

2. A confirmation screen will ask you if you want change the password. Select

Yes

Note: Once you select Yes, you must enter a password. The password can be the same as the
previous password.

3. Enter the password using the u, d, l, r or enter buttons. The password will be displayed

as ****. The numeric values of the buttons are:

4. Re-enter your password. When the correct password has been entered, a “Password

accepted” message appears.

Note: If the wrong password is entered three times in succession, the message “The projector's
operation will be locked.” is displayed for approximately five minutes, and then the projector
switches to standby mode. If this happens, disconnect the power cable from the electrical outlet
and then reinsert it and turn the projector's power back on. The projector displays the password
entry screen again so that you can enter the correct password.

If you continue to repeat the above operation and input the wrong password thirty times in
succession, you see the message “The projector's operation will be locked. Contact Epson as
described in your documentation.” and the projector will not accept any more password entries.