Epson 6100i Guide D’Installation Rapide
1
If you’ve turned on your notebook and you don’t see an image, press
the Source Search button on the projector to select the image source.
NOTE:
If you still see a blank screen or have other display problems,
see the troubleshooting tips on the back of this sheet.
2
Open the lens access door.
3
Turn the focus ring to
sharpen the image.
Turn the zoom ring to
reduce or enlarge
the image.
reduce or enlarge
the image.
4
If your image looks like
or
, you’ve placed the projector off
to one side of the screen at an angle. Place it directly in front of the
center of the screen, facing the screen squarely.
center of the screen, facing the screen squarely.
5
If your image looks like
or
, press the
or
buttons
on the projector to correct it.
1
Turn on your notebook.
2
Make sure the projector’s
Power light is orange
and not flashing.
3
Press the Power button
to turn on the projector.
T
urn on your equipment
C
onnect the projector
to your notebook
Follow these instructions to connect the projector to your
notebook. For other setup options, see your User’s Guide.
notebook. For other setup options, see your User’s Guide.
Epson
®
PowerLite
®
6100i
Quick Setup
Power cord
VGA computer cable
A
djust the image
CAUTION: Before unplugging the projector...
Shut down the projector properly:
1. Press the Power button twice.
2. When the Power light is steady orange, you can unplug the
projector.
With Epson’s exclusive Instant Off
TM
technology there’s no cool-down
period, so you can pack up and go immediately after turning off
the projector.
CAUTION: Never unplug the projector when the
Power light is
green or flashing orange.
Turn over
Power
button
Power
light
Zoom
Focus
1
Locate the required cables:
2
Connect the computer cable to
the blue Computer1 port
on the projector.
on the projector.
3
Connect the other end to your notebook’s video-out
or
monitor port.
NOTE:
If your notebook has a DVI connector, you need to use an
optional DVI-to-VGA adapter with the included computer cable
(see your computer’s documentation).
4
Connect the power cord to the
projector, then plug the other end
into an electrical outlet.