Emerson lc190em2 Mode D'Emploi

11

INTR

ODUCTION 

PREP

ARA

TION 

W

ATCHING TV 

USING FUNCTIONS

USEFUL TIPS

 

CONNECTING DEVICES

INFORMA

TION 

English

 

Initial Setup

This section will guide you through the unit’s initial setting 
which includes selecting a language for your on-screen menu 
and autoprogram, which automatically scans and memorizes 
viewable channels.

Make sure the unit is connected to antenna or cable.

1

  After making all the necessary connections,

press   to turn on the unit.
•  It may take a few moments to turn on the unit for the 

first time.

•  [Initial Setup] menu appears automatically after the 

unit is turned on.

2

 Use 

▲/▼ to select the on-screen language from the 

choices (English / Español / Français) on the right side of the 
TV screen, then press OK.

3

 Use 

▲/▼ to select [Antenna] for TV channels or [Cable] 

for CATV channels, then press OK.

Make sure the antenna is connected to ''ANT. IN'' jack.
Select your signal source.

•  [Autoprogram] will begin.

Please wait while the system is scanning for channels. 

Auto programming may take more than 20 minutes to 

complete.

4

 Use 

◄/► to select the desired location setting, then press 

OK.
[Home] is ENERGY STAR

®

 qualifi ed setting.

Select “Retail” or “Home” for your location.

• Select [Retail] store, the unit will be set up with 

predefined setting for retail displays. In this setting, the 

power consumption may possibly exceed the limited 

requirement of the ENERGY STAR

®

 qualification.

• Select [Home], the unit is set to maximize the energy 

efficiency for home setting and it can be adjusted 

through a choice of picture and sound quality according 

to your preference. Use this setting to remove the 

E-Sticker if visible from the display. 

➠

 p. 23

•  When the initial setup is completed, the lowest 

memorized channel with the confirmation message of 

the location setting will be displayed on the TV screen.

•  You must set [Home] in step 4. Otherwise, [Picture] 

and [Sound] settings you adjusted will not be 

memorized after the unit goes into standby mode.

Note

 

•  If you are not receiving a signal from your cable service, contact 

the Cable provider.

 

• If you press   or MENU during autoprogram, this setup of  TV 

channels will be canceled.

 

• The initial autoprogram function can be executed for either 

[Antenna] or [Cable] only once. When you change the 

connection  (Antenna / Cable),  set  [Autoprogram] again. 

➠

 p. 17

 

• If there is no signal input from the antenna terminal and no 

operation for several seconds after you turn on the unit, helpful 

hints appears. Follow the instructions listed on the TV screen.

No channel is registered.

Try Autoprogram again?

Verify that you have a cable connected to the "ANT. IN" jack 

on the back of the TV, the channel installation process 

searches this connection. If you are using a cable or satellite 

box, please confirm the input which you have connected to the 

box and press “SOURCE” key on the remote control to select 

the appropriate source input.

•  If you want to scan the channels automatically again.

[Autoprogram] 

➠

 p. 17

•   You can add the desired cable and analog channels 

unmemorized by autoprogram.
[Add Channels] 

➠

 p. 18

•  If you want to change to another language.

[Language] 

➠

 p. 23

•  If you want to change the location setting.

[Location]  

➠

 p. 23