Audiovox MP6211 Mode D'Emploi

Page de 52
MP6211
15
TROUBLESHOOTING
SPECIFICATIONS
CEA Power Ratings
Power Output  . . . . . . . . . . . . . . . .13 watts RMS X 4 channels into 4-ohms @ < 1% THD+N
Signal to Noise Ratio. . . . . . . . . . . . . . 70dBA below reference. (Reference: 1 watt, 4-ohms)
Dynamic Power . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 64 Watts @ 4 ohms all channels driven
Frequency Response  . . . . . 20Hz to 20kHz (-3dB), Auxiliary input used as source reference
Reference Supply Voltage. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 14.4VDC 
CD Player
Signal-to-noise ratio  . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .>90dBA
Frequency response . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .  20Hz-20kHz, -3dB
Channel separation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . >55dB @ 1kHz
D/A converter  . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .  1 Bit/CH
FM Tuner
Tuning range . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 87.5MHz-107.9MHz
Mono sensitivity. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .  12dBf
50dB quieting sensitivity (stereo)  . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .  16dBf
Stereo separation @ 1kHz  . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . >30dB
Frequency response . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 30Hz-12kHz. +3dB
AM Tuner
Tuning range . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .  530kHz-1710kHz
Sensitivity @ 20dB signal to noise  . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 30uV
Frequency response . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 30Hz-2kHz., -3dB
Auxiliary Input
Input sensitivity . . . . . . . . . . . . . . . . . . . . . . . . . . . .400mV RMS for 1 watt RMS into 4-ohms
Frequency response . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .  20Hz to 20kHz, -3dB
Input impedance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .10 k-ohms
General
Power supply. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .  11-16 VDC, negative ground
Fuses. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .  15 amp fast blow ATO
DIN chassis dimensions  . . . . . . . . . . . . . . . . .  2"H x 7"W x 7"D (51mm x 178mm x 178mm)
Specifications subject to change without notice.
Problem
Cause
Corrective Action
Does not operate 
(display does not light)
No power to yellow wire; no 
power to red wire
Check connection with test light; 
check vehicle fuse with test light
Inline fuse blown
Replace fuse
No power to unit
Inline fuse blown
Check/replace fuse
No speakers operate 
(display lights normally)
Speaker harness not 
connected
Connect speaker harness; check 
speaker wires
Not all speakers 
operate
Incorrect splices or 
connections
Check all splices and connections
Speaker wires shorting to 
chassis ground or to each 
other
Check splices, insulate all bare wires
Blows fuses
Power wire shorting to 
ground
Make sure wire is not pinched
Speaker wires shorting to 
ground
Make sure wire is not pinched
Incorrect fuse/fuse too small
Install fuse of correct rating