Cnet CWR-901 Mode D'Emploi
routing tables do not adjust to network changes, so they work best where routes do not change.
-
Route: The network address of the destination LAN segment. Packets with
destination IP addresses matching this field will be routed to the device set in the
Next Hop IP field.
destination IP addresses matching this field will be routed to the device set in the
Next Hop IP field.
-
Route Mask: Destination Network mask
-
NextHop IP: Next hop router for this packet.
-
Interface: You can select to use LAN or WAN as the physical interface from where
the packets will be sent.
the packets will be sent.
-
Save: Save the parameters.
-
Reset: Click on “Reset” button to undo your changes.
-
Help: To request help information.
3.8.3 RIP
You can configure this wireless router to receive and send RIP Version 1 or RIP Version 2 packets.
RIP Version 1 does not support authentication. If you are sending and receiving RIP Version 2
packets, RIP authentication can be enabled on an interface.
Routing protocols use several timers that determine such variables as the frequency of routing
updates, the length of time before a route becomes invalid, and etc. You can adjust these timers to
tune routing protocol performance to better suit your network needs. The following timer
adjustments are available :
RIP Version 1 does not support authentication. If you are sending and receiving RIP Version 2
packets, RIP authentication can be enabled on an interface.
Routing protocols use several timers that determine such variables as the frequency of routing
updates, the length of time before a route becomes invalid, and etc. You can adjust these timers to
tune routing protocol performance to better suit your network needs. The following timer
adjustments are available :
41