Sony KLV-32M1 Mode D'Emploi

27

Connecting and Setting the TV

Connect the satellite antenna cable to the satellite receiver’s SATELLITE
IN jack.

Connect the CATV cable to the VCR’s VHF/UHF IN jack.

Using the supplied 75-ohm coaxial cable, connect the VCR’s OUT jack
to the TV’s VHF/UHF jack.

Using A/V and S VIDEO cables, connect the satellite receiver’s AUDIO
and S VIDEO OUT jacks to the VCR’s AUDIO and S VIDEO IN jacks.

If your VCR or satellite receiver is not equipped with S VIDEO, use a VIDEO cable
(yellow) instead of the S VIDEO cable.

Using A/V and S VIDEO cables, connect the VCR’s AUDIO and S
VIDEO OUT jacks to the TV’s AUDIO and S VIDEO IN jacks (VIDEO
1 IN or VIDEO 3 IN).

When you connect video equipment to both the VIDEO and the S VIDEO input jacks, make sure
“Auto YC” in the 

 (Setup) menu is set to “On” to view the S VIDEO input (see page 25).

• You can also use the VIDEO 2 IN jacks located on the front of the TV to connect your VCR.
• Be sure your VCR’s video input is set correctly. Consult your VCR’s operating manual for

instructions.

• Use VIDEO 1/2/3 on the remote control to select VIDEO 1 IN (or VIDEO 3 IN if you use

the VIDEO 3 IN jacks for this hookup) to watch satellite TV or to watch a tape on the VCR
(your VCR must be turned on).

VIDEO (yellow)

AUDIO-R (red)

VCR

S VIDEO

75-ohm coaxial
cable (supplied)

AUDIO-L (white)

A/V cable
(not supplied)

Satellite Receiver

CATV cable

S VIDEO
cable
(not supplied)

A/V cable
(not supplied)

75-ohm coaxial
cable (supplied)

S VIDEO cable
(not supplied)

Satellite
antenna
cable

Rear of TV