Southbend eh-10cch Mode D'Emploi
T
ROUBLESHOOTING
H
ALF
-S
IZE
E
LECTRIC
C
ONVECTION
O
VENS
P
AGE
38
O
PERATOR
’
S
M
ANUAL
1184093
TROUBLESHOOTING
BLOWER WHEEL REPLACEMENT
To replace the blower wheel, do the following:
1. Remove racks and rack guides.
2. Remove side air baffle in front of blower wheel.
3. Loosen the two square heads on blower wheel hub.
4. Pull blower wheel from motor shaft. If blower wheel is difficult to pull off, use puller disk (available from
Southbend as part number 1179100).
WIRING DIAGRAMS
A wiring diagram is located on the side of the control panel assembly (as shown on page 37). Wiring
diagrams also appear on the following pages of this manual. Which wiring diagram is appropriate depends
on the voltage and type of controls.
diagrams also appear on the following pages of this manual. Which wiring diagram is appropriate depends
on the voltage and type of controls.
Index of Wiring Diagrams
Page Number
Voltage and Type of Controls
208-240 Volt Models with Standard Controls
480 Volt Models with Standard Controls
415/240 Volt Models with Standard Controls
380/220 Volt Models with Standard Controls
208-240 Volt Models with Cycle/Cook & Hold Controls
480 Volt Models with Cycle/Cook & Hold Controls
415/240 Volt Models with Cycle/Cook & Hold Controls
380/220 Volt Models with Cycle/Cook & Hold Controls
208-240 Volt Models with Programmable or Rack Timer Controls
480 Volt Models with Programmable or Rack Timer Controls
415/240 Volt Models with Programmable or Rack Timer Controls
380/220 Volt Models with Programmable or Rack Timer Controls