Manualsbrain.com
  1. Manuels
  2. Marques
  3. Standard Horizon
  4. cpn1010i
  5. Mode D'Emploi

Standard Horizon cpn1010i Mode D'Emploi

Télécharger
Page de 188
Page 150
Owner’s Manual
Before drilling holes make sure there is enough room to mount the CPN Series Chart Plotter and  there
are no obstructions.
1. After a location is found, peel the template label from the backing and apply the label
to the mounting area.
2. Drill a hole in one area of the cutout area that will allow the blade of a jig saw to be
inserted. Insert and cut out the area on the panel using the jig saw.
3. Next drill the four holes required to insert the CPN Series Chart Plotter with the mounting
studs.
4. Install pieces into mounting holes on the side of the CPN Series Chart Plotter before
inserting plotter into mounting hole.
5. Slide the CPN Series Chart Plotter into the dash of mounting hole.
6. Install the left and right brackets using the four lock washers and 4 screws (see A).
7. Tighten the four tension screws to hold the CPN Series Chart Plotter into the panel
(see B).