Standard Horizon cpn1010i Mode D'Emploi

Page 20

Owner’s Manual

Plotter is computing something. You can choose to wait until done or tap on 

 on the

display to exit.

To select and activate a desired item:

· Tap your finger on the display over the item

or

· Move the 

 ShuttlePoint knob up/down to place cursor on the item and then press the

 ShuttlePoint knob to enter (if enabled, see ShuttlePoint Enter item in the Par. 2.1.4

“Settings in General Setup Menu”)

or

· Move the 

 rotary knob left/right to place cursor on the item and then press the 

 rotary

knob to enter

Refer to the following example:

A. Tap on DISPLAY COLOR. A popup window will be shown with the available options.

To set Normal palette tap on Normal.

or
B. Move the 

 ShuttlePoint knob up/down to highlight DISPLAY COLOR and press the

 ShuttlePoint knob to enter. A popup window will be shown with the available options.

To set Normal palette move the 

 ShuttlePoint knob up/down to highlight Normal and

press the 

 ShuttlePoint knob to enter.

or
C. Move the 

 rotary knob left/right to highlight DISPLAY COLOR and press the   rotary

knob to enter. A popup window will be shown with the available options. To set Normal
palette move the 

 rotary knob left/right to highlight Normal and press the   rotary knob

to enter.

The CPN700i and CPN1010i in addition to being able to control functions with the touch
display, also have dedicated keys and knobs provided for your convenience. You will notice
when a key is pressed a single beep will be produced which means the key press is valid.
When a key press is not valid the CPN Series Chart Plotter will produce 2 beeps.