Standard Horizon cpn1010i Mode D'Emploi
CPN700i and CPN1010i Multimedia Chart Plotters
Page 69
(see B) and the relative dangerous Route leg (drawn with a different color - see A).
· Route legs which were classified as dangerous are displayed in RED. It means that
there is at least one dangerous object in the vicinity of this leg and it has been found.
· Route legs which were classified as safe are displayed in GREEN. It means that the data was
checked on detailed chart levels and no problems were found for all segments of the leg.
· Route legs for which there was not sufficient data to be checked are displayed in
YELLOW. It means that no problems were found but the data was not sufficient or not
available at all to classify such a leg as safe.
available at all to classify such a leg as safe.
To activate the Route Check function:
1. Press the
1. Press the
key, tap on User Points.
2. Tap on ROUTE. The Route menu appears.
3. Tap on ROUTE CHECK. The Route Check menu appears. See the following table.
3. Tap on ROUTE CHECK. The Route Check menu appears. See the following table.
Automatic Check
: Turns the Route Checking feature On or Off. Turn the Automatic Route Check On after
you have created a new Route (or if you inserted a new Waypoint, deleted, moved or
edited any Waypoint in a saved Route) to confirm the Route can be safely navigated.
edited any Waypoint in a saved Route) to confirm the Route can be safely navigated.
Route Width
: Allows you to select the width from the left and right of the Route leg where the CPN
Series Chart Plotter will check to confirm navigation threats. See the following picture.
The default setting is 0.04Nm.
The default setting is 0.04Nm.
Depth Limit
: Allows you to select the water depth in the Route width area so the CPN Series Chart
Plotter can check and confirm underwater threats. It checks if some objects with the
depth attribute (like Shallow Water, Dredged Areas, Diffusers, Obstructions, Pingos,
Production Installation and Wrecks) are above this depth level. Only if the depth attribute
is above the depth limit are they found and considered as dangerous. See the following
picture. The default setting is 10ft.
depth attribute (like Shallow Water, Dredged Areas, Diffusers, Obstructions, Pingos,
Production Installation and Wrecks) are above this depth level. Only if the depth attribute
is above the depth limit are they found and considered as dangerous. See the following
picture. The default setting is 10ft.
Accuracy
: Defines a segment length into which a leg of the Route is divided in order to execute the
search for dangerous objects with better accuracy. When accuracy is maximal, a
segment length is the shortest. When accuracy is minimal, a segment length is the
longest. Select among Minimum, Low, Medium, High and Maximum. See the following
picture. The default setting is Medium.
segment length is the shortest. When accuracy is minimal, a segment length is the
longest. Select among Minimum, Low, Medium, High and Maximum. See the following
picture. The default setting is Medium.
Route Check Report
: Shows the list of the dangerous objects found on the charts crossed by the Route.
Although the functionality is called Route Check, it can also be activated when the navigation is set to a
single point (like DSC, MOB, Mark). In the case of checking a single point towards which the navigation
is started, the leg for which the Route Check is executed is defined by the current position (the leg’s starting
point) and the destination point (the leg’s ending point).
single point (like DSC, MOB, Mark). In the case of checking a single point towards which the navigation
is started, the leg for which the Route Check is executed is defined by the current position (the leg’s starting
point) and the destination point (the leg’s ending point).