Standard Horizon cpn1010i Mode D'Emploi

Page 74

Owner’s Manual

3. Tap on CURSOR.
4. The CPN Series Chart Plotter now navigates from your current position to the location

selected at step 1. A bearing line between the vessels location and the destination point
is shown. A popup window shows the Distance (DST) and Bearing (BRG) from the
vessel’s location to the destination point (see B and C).

5. The CPN Series Chart Plotter is in Cursor Mode; to switch to Home Mode press the 

key so the vessel will stay in the center of the page.

It will also automatically switch to Home Mode after the timeout set in Home Mode Revert.

6. Soft Keys are also shown that allow you to quickly switch to the Highway page or to stop

navigation.

7. To stop navigation, press the 

 key and a Warning window is shown. Tap on  

.

After you have created a few Routes, you can choose one of them to GOTO.

1. Tap on an open position (no buoy, warning etc. under the cursor) on the Chart page.

2. Press the 

 key to show the GOTO popup window (see A).

If you place cursor over a cartographic object the GOTO popup window will be shown too. The only
situation when GOTO will not show this popup window but will start navigation straight away is when the
cursor is over a User Point. In such a case the navigation will be started directly to the selected User Point.
The 

 key will not work when a warning, alarm etc. window is displayed on the screen.

3. Tap on ROUTE.
4. The SELECT ROUTE window will be shown (see B).
5. Select the desired Route by moving the 

 ShuttlePoint knob up/down or turning the 

rotary knob to left/right or touching the scroll bar up/down and tap on it.