Summit sprf26m Mode D'Emploi

 

 

1.  Plug the DC/DC power cord into the cord socket on the side of 

the unit (see upper figure on page 5).   

2.  If using a DC power source such as the cigarette lighter socket 

of a vehicle, plug the other end of the cord into the power 
source. 

3.  If using an AC power source, connect the AC/DC adapter to 

the end of the DC/DC cord, then plug the adapter into a wall 
socket or other AC power source. 

4.  Press the power switch to turn on the cooler.  (You will hear the 

sound of the compressor starting.) 

5.  Press the Up or Down button on the control panel to adjust the 

temperature.  Pressing either button once will adjust the tem-
perature by 1Celsius degree.  The maximum cool setting is  
-19°C (-2.2°F). 

6.  Five seconds after the desired temperature is set, you will hear 

5 beeps to confirm the setting and the LED display will begin to 
show the actual temperature inside the unit. 

NOTE: The compressor will shut off if the internal temperature of 

the unit is 1 Celsius degree or more below the set temperature.  
When the internal temperature rises to 2 degrees above the set 
temperature, the compressor will turn on again after an interval 
of about 2 minutes. 

 

 Place the cooler in a cool, dry place away from direct sunlight. 
 Cool the food or drink before storing in the cooler. 
 Do not set the temperature colder than you require. 
 Do not open the cooler more often than necessary. 
 Do not leave the lid open longer than necessary,