Chief KTG220B Manuel D’Utilisation

Model: KTG-Series

Installation Instructions

To install on a flat surface:

1.

Locate desired point on surface where mount is to be
installed. (see Figure 2)

2.

Drill a 1/2" dia. hole through surface.

3.

Slide one 3/8-16 x 6" HHCS (100) upward through
lower grommet (110), through hole in surface and
through upper grommet (110).

4.

Place pole (50, 60, 70) onto upper grommet (110)
aligning threaded hole in pole bottom with threaded
end of 3/8-16 x 6" HHCS (100).

5.

Thread 3/8-16 x 6" HHCS (100) into pole bottom (50,
60, 70) and tighten to secure pole and grommets
(110) to surface.

6.

Add pipe cap (40) to top of pole.

7.

Mount Centris head assembly or array assembly to
rail following the instructions outlined in KTG-220,
320, And 440 Assembly section of this document.

8.

Place front pole clamp with Centris Head (210)
against pole in approximate mounting location.

9.

Place three BHCS (230) into rear pole clamp (220)
and place against pole aligning with front pole clamp
(210). (see Figure 3)

(10 Includes 210, 220, 230)

(20)

(30)

(50)

(60)

(70)

(80)

(100)

(110)

(120)

(130)

(140)

(160)

(170)

(180)

(190)

(200)

240

250

260

(40)

1/2" dia.
through hole

(110)

(110)

(50, 60, 70)

(100)