APC SurgeArrest PM 208/120V 80KA, Non-modular PMF2X-A Manuel D’Utilisation

The option has two LEDs, one red and one green, and an audible alarm with 
an enable/disable switch. Normal status is a lit green LED, and no audible 
alarm. To test the integrity of the remote monitor, press the push-to-test 
switch. The green LED will turn off, the red LED will turn on, and the alarm 
will sound, if the alarm is enabled. Releasing the switch will complete the 
test; the red LED will turn off, the green LED will turn on and the alarm will 
shut off.

If protection on any phase is lost, the green LED will turn off, the red LED 
will illuminate and an alarm will sound. The audible alarm can be silenced by 
pushing the alarm enable/disable/test switch. The alarm will silence and the 
green alarm LED will not be lit. The red LED will continue to be illuminated 
until the inoperative condition has been cleared.

The remote monitor includes a 120 Vac to 12 Vdc adapter with a six-foot 
power cord. Connections are made to the PM2X SPD diagnostic panel with 
the 24-inch dry contact leads (provided). To extend the remote monitor 
further (up to 1,000 ft. [305 m]), use an additional length of solid or stranded 
30 to 14 AWG wire (not provided).

 

= OK

= Fault / Falla / Défaut

Bouton pousser pour vérifier

[63.5]

2.500

[31.8]

1.25

[88.9]

3.500

[100.3]

3.950

[5.86]

0.230

[5.86]

0.460

[4.75]

2x Ø 0.187

[111.76]

4.400

[3.3]

0.130

[28.58]

1.125

Dry Contacts

120 V power cord