Canon LV-8320 Manuel D'Instructions

64

Unplug the AC power cord before cleaning.

Gently wipe the projection lens with a cleaning 

cloth that contains a small amount of non-

abrasive camera lens cleaner, or use a lens 

cleaning paper or commercially available air 

blower to clean the lens. 

Avoid using an excessive amount of cleaner. 

Abrasive cleaners, solvents, or other harsh 

chemicals might scratch the surface of the lens.

Unplug the AC power cord before cleaning.

Gently wipe the projector body with a soft dry 

cleaning cloth. When the cabinet is heavily soiled, 

use a small amount of mild detergent and finish 

with a soft dry cleaning cloth. Avoid using an 

excessive amount of cleaner. Abrasive cleaners, 

solvents, or other harsh chemicals might scratch 

the surface of the cabinet.

When the projector is not in use, put the projector 

in an appropriate carrying case to protect it from 

dust and scratches.

When moving this projector or while not using it 

over an extended period of time, attach the lens 

cap.

Attach the lens cap according to the following 

procedures.

Thread the string through the hole on the 

lens cap and then tie a knot in the string to 

secure it in place.

To pass the other end of the string into the 

hole on the bottom of the projector and pull 

at it.

Do not use any flammable solvents or air 

sprays on the projector and in its vicinity. 

The explosion or fire hazard may occur 

even after the AC power cord is unplugged 

because the temperature inside the projector 

is extremely high due to the lamps. In 

addition, there is a risk that the internal parts 

may be damaged not only by the flammable 

air spray but also by the cold air.