Canon LV-8320 Manuel D'Instructions

67

 Problem: 

– Solutions

 No power 

– Plug the power cord of the projector into the AC outlet. 

   

– See if the POWER indicator lights red. 

   

–  Wait until the POWER indicator stops blinking to turn on the 

projector again. The projector can be turned on after the 

POWER indicator turns red. See page 20.

   

– Check the WARNING indicator. If the WARNING indicator lights  

   

  red, projector cannot be turned on. See page 72. 

   

– Check the projection lamp. See page 65. 

   

– Unlock the Key lock function for the projector. See page 57.

The initial display is not shown. – Make sure Off or Countdown off are not chosen at display 

   

  function. See page 48.

The initial display is not same – Make sure User or Off are not chosen at Logo (select)

as the default set.                              function. See page 48.

Input signal switches automatically.    – Make sure Auto input function is adjusted properly.  

(or does not switch automatically)          See page 47.

An icon other than Input mode   – That is the Lamp replacement icon or the Filter warning icon.   

or Lamp mode icon appears. See page 65 or 59.

Image is out of focus. 

– Adjust focus of the projector. See page 25. 

   

– Provide proper distance between the projector and the  

 

   

  projection screen. See page 15. 

   

– Check the projection lens to see if it needs cleaning. 

   

  See page 64. 

   

– Moving the projector from a cool to warm place may result in    

   

  moisture condensation on the projection lens. In such cases, 

   

  leave the projector off and wait until condensation evaporates.

Image is Left/Right reversed. 

– Check the Ceiling/Rear function. See pages 37, 45. 

Image is Top/Bottom reversed.  – Check the Ceiling function. See pages 37, 45.

 

– Check if the 

Contrast or Brightness is adjusted properly.  

                                                            See pages 35, 42.

   

– Check if 

Image mode is selected properly. See pages 34, 41.

   

– Check the Lamp mode function. See pages 27, 56.

   

– Check the LAMP REPLACE indicator. If it lights, the end of lamp

   

   life is approaching. Replace the lamp with a new one promptly. 

                                                            See page 65.

Before calling your dealer or service center for assistance, check the items below once again.

–  Make  sure  you  have  properly  connected  the  projector  to  peripheral  equipment  as  described  on 

pages 16-18. 

–  Make sure all equipment is connected to AC outlet and the power is turned on.

–  When the projector does not project an image from the connected computer, restart the computer.