Canon VB-R13 Manuel

Setting Page

173

• If [Basic] > [Video] > [All Videos] > [Video Size Set] settings on the Setting Page are changed, be sure to change the

preset position settings (

) and Intelligent Function settings, and check operations. The Intelligent

Function may not operate, depending on the settings.

• Please set the Intelligent Function again if the angle of view has changed through camera operation, or the preset/home

position has changed.

• If [Status] in [Detection Setting List] has [Enabled] when the camera position is fixed, control privileges cannot be

obtained by the Camera Viewer or RM Viewer. Also, the preset tour will no longer run.

• If you use a preset registered with the digital zoom, the camera position at registration may not be able to be reproduced

with a high degree of accuracy. Therefore, it is recommended that you use a preset registered in the optical zoom area

for the intelligent function.



Difficult-to-Detect Subjects

The following subjects may not be detected, or may result in erroneous detection.

• Objects or areas where there is little contrast in color or brightness with the background may not be detected.

• Small objects and changes on the screen may not be detected.

• Partial or entire changes in brightness on the screen may trigger detection.

• When there are multiple overlapping objects, there may be a change in detection. For example, objects passing

may either not be detected or the timing of detection may be incorrect.

• When there are large numbers of objects in the scene, objects may not be properly detected.

Registering Presets

It is strongly recommended that you register the camera angle as a preset in advance and lock the camera to that position

when using video detection. It is also recommended that the field of view that captures targeted objects at a larger ratio be

used.

For details on preset registration, please refer to “[Camera] > [Preset] Registering Presets” (P. 131).

Selecting the Intelligent Function Operation Mode

Video detection and auto tracking cannot be used simultaneously. You can select which one to use on the Setting Page for

the intelligent function.

Note

The applied settings are retained even if you change operation modes.

The currently selected operation mode changes to purple.

R13 R12 M50

R13 R12

Select [Video Detection] or [Auto Tracking].

Important

[Video Detection] and [Auto Tracking] are exclusive of each other. Only the selected mode operates, the other is disabled.
In addition, if you change to the other operation mode without clicking [Apply], settings changed in the current mode are lost. Be
sure to click [Apply] to save the changed settings.

Read the displayed message, and click [OK] or [Cancel].