Canon VB-H651V Mode D’Emploi

Setting Page

5

135

If you select [Enable] for the area with the frame color you would like to use for the specified area, the frame will be 

displayed on the Viewer.

Set the specified area as follows within the display area.

• Drag out a frame and move it to the area you want to specify.

• Change the size of the frame by dragging any of the eight handles (

■).

• If you want to change the camera angle, use the pan/tilt/zoom sliders.

[Preview] 
The camera will move to a specified area if you click [Preview] for that area.

Note

You can use the Camera Viewer to check video with ADSR settings applied. Video outside the specified area will deteriorate according to 
the amount of applied data reduction.

ADSR

Set whether H.264(1) and H.264(2) will lower video quality outside areas set with [Specified Area].

[Enable in H.264(1)]
Select [Enable] to lower video quality of outside areas set with [Specified Area] in H.264(1) video.

[Enable in H.264(2)]
Select [Enable] to lower video quality of outside areas set with [Specified Area] in H.264(2) video.

[Data Size Reduction Level]
Set the data size reduction level for the outside area of [Specified Area]. If you select [Low], the data size reduction effect is 

lower. If you select [High], the data size reduction effect is higher.

Important

• If you change the [Image Flip] setting in [Camera] > [Installation Conditions], review the specified area settings.

• Reconfigure the specified area if you change the [Video] > [All Videos] > [Video Size Set] settings.

• Configure the specified area to a slightly larger size.

• Specified areas may deviate slightly from the specified position depending on the zoom position.

• The selected area can only be set within the optical zoom range, and cannot be set using the digital zoom range (P. 66).

M50

M50

M50