Canon LV-7490 Brochure
1
Chapter 2 Setup Procedures
Setting procedures and contents differ depending on the LAN installation location.
When installing, consult your system administrator to set up the LAN appropriately.
When installing, consult your system administrator to set up the LAN appropriately.
Connect the LAN cable to the LAN connection terminal of the projector.
Network configuration
Set the Wired LAN network through the projector menu. Detailed network settings will be
made with browser. Refer to “3. Basic setting and operation” (p.17-30). First, complete the
settings described in this chapter before performing steps in “3. Basic setting and opera-
tion.”
made with browser. Refer to “3. Basic setting and operation” (p.17-30). First, complete the
settings described in this chapter before performing steps in “3. Basic setting and opera-
tion.”
Connecting to the LAN line
Setting Procedure
1. Select “LAN mode select” in the Network menu, and press Point
8
or OK button.
2. Select similar LAN environment among LAN1, LAN2 and LAN3 with the Point
ed
buttons, and press OK button. Then the Menu will disappear, the “Please wait...” mes-
sage will appear, and switching operation will start. Switching will take a while and the
projector’s LINK/ACT Lamp will be on or blink, and after completing the operation, the
“Please wait...” message will disappear.
sage will appear, and switching operation will start. Switching will take a while and the
projector’s LINK/ACT Lamp will be on or blink, and after completing the operation, the
“Please wait...” message will disappear.
LAN Cable
LAN Connection
Terminal
Terminal
LINK Lamp (Green)
Light green when the
projector is connected to
the network correctly.
Light green when the
projector is connected to
the network correctly.
ACT Lamp (Orange)
Blink orange when the
projector is sending or
receiving the data.
Blink orange when the
projector is sending or
receiving the data.
* Please use a shielded LAN cable.