Canon DP-V3010 Manuel

48

OSD Menu

Item

Setting Options (underline indicates factory default)

Calibration

Performs calibration based on set target values when "User 1-7" is selected for "Picture Mode".
Luminance: Sets the target luminance.

48 to 200 cd/m

2

Color Temperature: Sets the target color temperature.

D93, D65, D61, D60, D56, D50, DCI-P3: Select from preset color temperatures.

Custom (xy): You can adjust CIE x, y in increments of 0.001.

x: 0.260 to 0.360 (0.314)/y: 0.260 to 0.360 (0.351)

Color Gamut: Sets the color gamut.

Gamma: Sets the target gamma.

Start: Performes calibration.

Note

•  When "Luminance" is set to high brightness, it may be calibrated beyond the brightness

adjustment range and set lower than the target value depending on the "Color Temperature"
setting. In that case, set the "Luminance" again.

Copy
Picture Mode

When "User 1-7" is selected for "Picture Mode", the content of the selected picture mode is copied.
The following modes can be selected:
Picture Mode: SMPTE-C, EBU, ITU-R BT.709, ITU-R BT.2020, Adobe RGB, DCI-P3, User 1-7 
(other than the currently set parameter)
Execute: Performs copy.

Picture Mode
Name

You can change the name of "User 1-7" within 16 characters including alphabetical characters,
numbers, and symbols.

Anchor Adjustment

Temporarily saves parameters while adjusting SHARPNESS, CHROMA, BRIGHTNESS, and
CONTRAST (anchor point setting).
OK: Performs anchor point setting.
Cancel: Returns to the previous screen without setting anchor point.

Reset

Return "Picture Mode" to factory default. Note that in "User 1-7" mode where you are performing
calibration, the setting returns to the value after calibration instead of the factory default.
When selected, the message "Reset Adjustment settings to defaults?" appears.
OK: Performs reset.
Cancel: Returns to the previous screen without resetting.