Canon DP-V3010 Manuel

OSD Menu

Item

Setting Options (underline indicates factory default)

Aspect Ratio

Sets the aspect ratio of the aspect marker.
16:9, 15:9, 14:9, 13:9, 4:3, 2.39:1, 2.35:1, 1.896:1, 1.85:1, 1.66:1, Variable

The aspect ratio can be entered as a numeric value when you select "Variable" (0.01:1 increments).
The grayed out slider becomes active and can be used to set the aspect ratio.
1.00:1 to 3.00:1 (1.78:1)

Line

Active when "Black" or "Half" is selected for "Mask". Switches lines on mask On, Off.
On, Off

Line Width

Sets the thickness of the aspect marker line.
Thick, Normal, Thin

Line Color

Sets the color of the aspect marker line.
White, Red, Green, Blue, Yellow, Cyan, Magenta

Line
Brightness

Sets the brightness of the aspect marker line.
High, Low

H Position

Changes horizontal position without changing the aspect.
-65 to 65 (0)

V Position

Changes vertical position without changing the aspect.
-35 to 35 (0)

Safety Zone Marker 1, 2 There are two types of safety zone marker: 1 and 2, which share the same settings. A safety zone

marker is used to set the safe zone of the image (actual displayed area) to check the image.

Note

• In the case of SDI signal, setting is disabled when "H Delay" or "V Delay" is "On".
• Safety zone marker is not displayed in the following cases:

When there is no signal, unsupported signal, or a channel with "Input Configuration" not set is
selected

When an enlarged image is displayed

During the execution of "Playback File" under "Screen Capture"

When "H Delay"/"V Delay" is "On"

When a "Test Pattern" is displayed

When "Peaking 1" or "Peaking 2" is selected

Enable

Switches the safety zone marker On, Off.
On, Off

Aspect Ratio

Sets the aspect ratio of the safety zone marker.
16:9, 15:9, 14:9, 13:9, 4:3, 2.39:1, 2.35:1, 1.896:1, 1.85:1, 1.66:1, Variable

Note

• When "Area Size" is set to "Variable (dot)", you cannot select "Aspect Ratio".