ASUS PQ321QE Mode D'Emploi

Installing the stand (supplied)

* If the monitor will be used in the portrait orientation, pull out

the fixing pin (1), and insert it into the hole (2) as shown

above.

* To remove the stand, place the monitor and stand as shown

above and remove the screws.

Caution

• Adhere to the following when installing the monitor in its

portrait orientation. Failing to adhere to the following may

cause malfunctions.

- Install the monitor such that the operation buttons are

located on the top side.

- Set the MONITOR on the MONITOR menu to PORTRAIT.

(See page 20.)

Operation buttons

Screw

(M4 x 10 with washers)

Front

Fixing pin

• Portrait

Screw

(M4 x 10 with washers)

5. Fasten the stand to the monitor with the supplied screws

(M4 x 10 with washers) (x4).

Use the supplied hex wrench.
• Landscape

Tab

3. Spread a thick, soft cloth (blanket, etc.) that will prevent

damage to the LCD panel on a stable flat surface where

the entire monitor can be placed, and place the monitor

with the LCD panel face down on the cloth.

4. Place the stand on the monitor.

Hook the tab on the stand under the mounting plate (pre-

installed on monitor).

* A bag containing the

screws (supplied) and

hex wrench (supplied) is

attached to the round hole

in the stand pedestal.

Countersunk screw

(M4 x 6 without washers)

Insert by hooking the tab

Pedestal

2. While supporting the stand pedestal with your hand,

fasten to the stand strut with the supplied countersunk

screws (M4 x 6 without washers) (x5).

Use the supplied hex wrench.

Front

Packing material

(upper left)

Caution

• Disconnect all cables from the monitor.

• Firmly tighten the installation screws (supplied) with the hex

wrench (supplied).

• Ensure that you have sufficient space to work.

Attaching the stand

Remove all packaging materials before starting work.

To prevent the table (etc.) from being damaged by the stand

pedestal, spread a thick, soft cloth (blanket, etc.) and work on

the cloth.

1. Insert the stand strut into the packaging material (upper

left) as shown.