ASUS E2KM1I-DELUXE Manuel D’Utilisation

CPU and chassis fan connectors (4-pin CPU_FAN, and 4-pin CHA_FAN)
Connect the fan cables to the fan connectors on the motherboard, ensuring that the 

black wire of each cable matches the ground pin of the connector.

• 

The CPU_FAN connector supports a CPU fan of maximum 2A (24 W) fan power.

• 

Only the 4-pin CPU fan and 4-pin chassis fan support the ASUS Fan Xpert feature.

DO NOT forget to connect the fan cables to the fan connectors. Insufficient air flow inside 

the system may damage the motherboard components. These are not jumpers! DO NOT 

place jumper caps on the fan connectors.

CHA_FAN

PWM Mode

CPU

FAN IN

CH

A

FAN PWR

GND

CPU_FAN

CPU

FAN PWM

CPU

FAN IN

CPU

FAN PWR

GND

Chassis intrusion connector (4-1 pin CHASSIS)
This connector is for a chassis-mounted intrusion detection sensor or switch. Connect 

one end of the chassis intrusion sensor or switch cable to this connector. The chassis 

intrusion sensor or switch sends a high-level signal to this connector when a chassis 

component is removed or replaced. The signal is then generated as a chassis intrusion 

event.
By default, the pin labeled “Chassis Signal” and “Ground” are shorted with a jumper 

cap. Remove the jumper caps only when you intend to use the chassis intrusion 

detection feature.

GND

Chassis Signal

+5VSB_MB

CHASSIS

ASUS E2KM1I-DELUXE

1-17