ASUS P9D-C/4L Manuel D’Utilisation

4

LSI Software RAID Configuration Utility 

The LSI Software RAID Configuration Utility allows you to create RAID 0, RAID 1, or RAID 

10 set(s) from SATA hard disk drives connected to the SATA connectors supported by the 

motherboard.

You must set the jumper settings of your motherboard to activate the LSI Software RAID

Configuration Utility.
To set the jumper settings, set the 3-pin RAID_SEL1 jumper to pins 1-2.

Before you proceed, ensure that you have installed the Serial ATA hard disk drives, set the 

correct jumper settings of the motherboard, and have set the correct SATA mode in the BIOS 

setup. You can refer to following sections for the instructions in Installing hard disk drives, 

Setting Jumpers, and Setting the RAID mode in BIOS.

The motherboard supports Serial ATA for RAID set configuration. For optimal performance, 

install identical drives of the same model and capacity when creating a disk array.

To install the SATA hard disks for RAID configuration:
1. 

Install the SATA hard disks into the drive bays following the instructions in the system 

user guide.

2. 

Connect a SATA signal cable to the signal connector at the back of each drive and to the 

SATA connector on the motherboard.

3. 

Connect a SATA power cable to the power connector on each drive.

LSI

The motherboard illustration is for reference only. Visit www.asus.com for the complete list 

of supported motherboards,