ASUS TS700-E7/RS8 Manuel D’Utilisation

TS700-E7/RS8

2-29

The barebone server system is shipped with four footpads attached to the bottom 

of the chassis for stability. You need to remove these footpads if you wish to install 

the system to a rack (Refer to Chapter 3: Installation options of this user guide, and 

to the “Rackmount Kit” user guide for instructions)

To remove the footpads:
1.  Lay the system chassis on its side.
2.  Remove the footpad by rotating 

it counterclockwise with a Philips 

(cross) screwdriver.

3.  Repeat step 1 and 2 to remove the 

other three footpads.

The system is compatible with the 620W (for Taiwan only) and 800W redundant 

power supply module. 

You MUST disconnect all power cable plugs from the motherboard and other 

installed devices before removing the power supply unit.

To install the redundant power supply module:
1.  Remove the redundant power 

supply dummy cover.