ASUS P9X79 DELUXE Manuel D’Utilisation

2-26

Chapter 2: Hardware information

These connectors connect to Serial ATA 6.0 Gb/s hard disk drives via Serial ATA 6.0 
Gb/s signal cables.

If you installed Serial ATA hard disk drives, you can create a RAID 0, 1, 5, and 10 
configuration with the Intel

®

 Rapid Storage Technology through the onboard Intel

®

 X79 

chipset.

• 

These connectors are set to [AHCI Mode] by default. If you intend to create a Serial 
ATA RAID set using these connectors, set the 

SATA Mode item in the BIOS to [RAID 

Mode]. Refer to section 

3.5.4 SATA Configuration for details.

• 

Before creating a RAID set, refer to section 

4.4 RAID configurations or the manual 

bundled in the motherboard support DVD.

• 

When using NCQ, set the 

SATA Mode in the BIOS to [AHCI Mode]. Refer to section 

3.5.4 SATA Configuration for details.

• 

You must install Windows

®

 XP Service Pack 3 or later versions before using Serial 

ATA hard disk drives. The Serial ATA RAID feature is available only if you are using 
Windows

®

 XP SP3 or later versions.

IRST driver note for OS installation

• 

 

32 bit: Intel IRST driver for X79 platform will NOT support Windows XP 32 bit. Please 
set to [IDE Mode] for OS installation.

 

64 bit: When [SATA Mode] is set to [AHCI Mode][RAID Mode], it is necessary to load 
IRST Driver from driver disk during OS Windows XP 64 bit installation for the system 
to detect the storage devices. For details, please refer to the section "4.5 Create a 
RAID driver disk". 

• 

Windows 7 & Vista: When [SATA Mode] is set to [RAID Mode], you must load IRST 

Driver during Windows 7 or Vista installation for the system to detect the Optical Disk 
Drive (the ODD should be connected to the Intel SATA ports), or else the ODD will not 
run. We strongly recommend you save the IRST Driver from SCD to the USB Flash 
Drive before OS installation.