ASUS PIKE II 3108-8i/16PD Mode D'Emploi

ASUS PIKE II 3108 Series

2-3

•  Having RAID 0 and RAID 5 virtual disks in the same physical array is 

 If a drive in the physical array has to be rebuilt, the 

RAID 0 virtual disk will cause a failure during the rebuild.

•  If you want to boot the system from a hard disk drive included in a created 

RAID set, copy first the RAID driver from the support CD to a floppy disk 

before you install an operating system to the selected hard disk drive.

The RAID card supports SAS for RAID set configuration. For optimal performance, 

install identical drives of the same model and capacity when creating a disk array.
To install SAS hard disks for RAID configuration:

1.  Install the SAS hard disks into the drive bays following the instructions in the 

system user guide.

2.  Connect a SAS signal cable to the signal connector at the back of each drive 

and to the SAS connector on the motherboard.

3.  Connect a power cable to the power connector on each drive.

The AVAGO MegaRAID SAS-MFI BIOS Utility is an integrated RAID solution that 

allows you to create RAID 0, 1, 10, 5, 50, 6, and 60 sets from SATA II/SATA III/

SAS/SAS II/SAS III hard disk drives supported by the LSI SAS 3108 12Gb/s SAS 

controller.
 

• 

Create drive groups and virtual drives for storage configurations

 

• 

Delete virtual drives

 

• 

Migrate a storage configuration to a different RAID level

 

• 

Detect configuration mismatches

 

• 

Import a foreign configuration

 

• 

Display controller, virtual drive, physical drive, and change parameters.

 

• 

Scan devices connected to the controller

 

• 

Initialize virtual drives

 

• 

Check configurations for data consistency

 

• 

Create a CacheCade™ configuration

•  You may use disks of different sizes; however, the size of the smallest disk 

determines the “logical” size of each member disk.

•  DO NOT combine Serial ATA and SAS disk drives in one volume.

•  The RAID setup screens shown in this section are for reference only and 

may not exactly match the items on your screen due to the controller 

version difference.