ASUS VivoMini UN45 Guide De Montage
6
7
8
9
10
Installing or upgrading the wireless card
To install or upgrade the wireless card:
1.
Follow steps 1-5 on pages 1-2 under the Installing or upgrading memory modules section
of this guide to remove the bottom cover of your VivoMini.
2.
Align and insert the wireless card into the lower slot inside the VivoMini. Refer to the
illustration for its location.
3.
Gently push down the wireless card on top of the screw holes and fasten it using the
3mm round screw.
Your VivoMini includes a mini-PCIe slot for half-size wireless and Bluetooth adapters.
Refer to http://www.asus.com for the list of compatible wireless and Bluetooth adapters.
10.
Place the rubber foot on each screw hole. Refer to the illustration for more details.
IMPORTANT! A number is printed under each rubber foot and this number
corresponds to that rubber foot’s location on the cover. Follow the orientation of each
rubber foot and the number sequence shown in the illustration below. The rubber
foot fits in only one orientation. Note the position of the hole on each rubber foot, as
shown in the illustration below
NOTE: If you want to remove the rubber foot, use a flathead screwdriver or a
straightened paper clip to do so.
Installing or upgrading the M.2 SSD
To install or upgrade a half-size M.2 SSD:
1.
Follow steps 1-5 on pages 1-2 under the Installing or upgrading memory modules section
of this guide to remove the bottom cover of your VivoMini.
5.
Follow steps 7-9 on pages 3-4 under the Installing or upgrading memory modules section
of this guide to replace the bottom cover back on your VivoMini.
Your VivoMini includes a PCIe slot that supports a full-size or a half-size M.2 SSD.
4.
Connect the black antenna to MAIN or and the white antenna to AUX or . Refer
to the illustration for the right installation procedure.
NOTE: A soft clicking sound indicates that the antenna has been securely attached on
the wireless card.
4.
Gently push down the half-size M.2 SSD on top of the screw hole and fasten it using
one of the 3mm round screw. Refer to the illustration for the location of the screw hole.
3.
Align and insert the half-size M.2 SSD into its slot inside the VivoMini. Refer to the illustration
for its location.
2.
Insert the hexagon screw, as illustrated.
3.
Gently push down the full-size M.2 SSD on top of the screw hole and fasten it using one
of the 3mm round screw. Refer to the illustration for the location of the screw hole.
4.
Follow steps 7-9 on pages 3-4 under the Installing or upgrading memory modules section
of this guide to replace the bottom cover back on your VivoMini.
2.
Align and insert the full-size M.2 SSD into its slot inside the VivoMini. Refer to the illustration
for its location.
5.
Follow steps 7-9 on pages 3-4 under the Installing or upgrading memory modules section
of this guide to replace the bottom cover back on your VivoMini.
To install or upgrade a full-size M.2 SSD:
1.
Follow steps 1-5 on pages 1-2 under the Installing or upgrading memory modules section
of this guide to remove the bottom cover of your VivoMini.