Canon imageCLASS MF249dw Manuel

1469-062

When connecting the machine to a wired or wireless local area network (LAN), you need to set an IP address unique to

the selected network. Select "wired" or "wireless" depending on your communication environment and networking

devices. For steps to connect the machine and set an IP address, see "Getting Started" (  Manuals Included with the

Machine(P. 660) ). For specific IP address settings, contact your Internet service provider or Network Administrator.

If the machine is connected to an unsecured network, your personal information might be leaked to a third

party.

●

The machine cannot connect to both wired and wireless LANs at the same time.

●

The machine does not come with a LAN cable or router. Have them ready as necessary.

●

For more information about your networking devices, see the instruction manuals for the devices or contact
your manufacturer.

◼

Before You Start

Follow these steps to connect the machine to a network.

 

 

●

Make sure that the computer is correctly connected to the network. For more
information, see the instruction manuals for the devices you are using, or contact the
device manufacturers.

●

Make sure that the network settings have been completed on the computer. If the
network has not been set up properly, you will not be able to use the machine on the
network, even if you perform the rest of the procedure below.

●

Depending  on  the  network,  you  may  need  to  change  settings  for  the
communication  method  (half-duplex/full-duplex)  or  the  Ethernet  type  (10BASE-T/
100BASE-TX)  (  Configuring  Ethernet  Settings(P.  373)  ).  For  more  information,
contact your Internet service provider or Network Administrator.

●

To check the MAC address of the machine.

Network

315