Canon imagePROGRAF iPF830 MFP M40 Manuel

Caution

Assemble the Stand

Install the Roll Unit

Install the Printer

Assemble the stand on which you will install the printer.

-> Refer to "Assemble the Stand" in the Printer Stand Setup Guide

Remove the packaging material and the

plastic covering from the other side of the

printer the same way.

Remove the packaging material on top of

the printer.

While two people hold the carrying handles

under the printer on one end and lift the

printer a little, have a third person remove the

packaging material and the plastic covering

from under the printer. After the packaging

material has been removed, lower the printer.

Pull out the roll unit.

With three people holding the carrying handles under the printer on both ends, lift the printer.

• The printer alone weighs approximately 2

kg. Moving the printer requires at least six

people, three on either side. Be careful to

avoid back strain and other injuries.

• When moving the printer, firmly grasp the

carrying handles (a) under each side. Holding

the printer at other positions is dangerous

and cause injury and damage if the printer is

dropped.

Attach the roll unit to the stand.

-> Refer to "Install the Roll Unit" in the Printer Stand Setup Guide

• When setting the printer down temporarily

make sure to put the printer on a flat, stable

place.

• When standing the printer up, make sure the

side with the control panel is up, and place

cardboard or other material underneath to

prevent scratching. Furthermore, make sure

that the weight of the printer is taken by the

corner of the printer. If the weight is taken by

any other part of the printer, the printer may

become damaged.

• When standing up the printer or supporting the

printer, hold the metal parts of the printer. If

you hold a plastic part, the printer may become

damaged.

• The way to set the printer down or to carry with

the load only to the center of the printer, may

cause damage to the printer.