Netgear FVS318Gv2 – ProSAFE VPN Firewall Series Guide D’Exploitation
Virtual Private Networking Using IPSec and L2TP Connections
274
NETGEAR ProSAFE VPN Firewall FVS318G v2
2.
In the left column
of the Configuration Panel screen, c
lick Global Parameters
.
3.
Specify the following default lifetimes in seconds to match the configuration on the VPN
firewall:
•
Authentication (IKE), Default. Enter 3600 seconds.
The default setting is 28800 seconds (eight hours). However, for a Mode Config
configuration, NETGEAR recommends 3600 seconds (one hour).
configuration, NETGEAR recommends 3600 seconds (one hour).
•
Encryption (IPSec), Default. Enter 3600 seconds.
4.
Select the Dead Peer Detection (DPD) check box, and configure the following DPD settings
to match the configuration on the VPN firewall:
•
Check Interval. Enter 30 seconds.
•
Max. number of entries. Enter 3 retries.
•
Delay between entries. Leave the default delay setting of 15 seconds.
5.
To use the new settings immediately, click the Apply button.
6.
To keep the settings for future use, click the Save button.
The Mode Config configuration of the VPN client is now complete.
Test the Mode Config Connection
To test the Mode Config connection from the VPN client to the VPN firewall:
1.
Right-click the system tray icon, and select Open tunnel ‘Tunnel_ModeConfig’.