Netgear M4100-12G-POE+ (GSM7212P) - 12-Port Managed Gigabit Switch Guide De Logiciel

Page de 578
Log Messages 
554
M4100 Series ProSAFE
 Managed
 Switches 
Technologies
Table 54.  System General Error Messages
Component
Message
Cause
OS 
Invalid USP unit = x, slot = x, port =x
A port was not able to be translated 
correctly during the receive.
OS 
In hapiBroadSystemMacAddress call to 
'bcm_l2_addr_add' - FAILED : x
Failed to add an L2 address to the MAC 
table. This should only happen when a 
hash collision occurs or the table is full.
OS 
Failed installing mirror action - rest of the 
policy applied successfully
A previously configured probe port is not 
being used in the policy.  The release notes 
state that only a single probe port can be 
configured
OS 
Policy x does not contain rule x
The rule was not added to the policy due to 
a discrepancy in the rule count for this 
specific policy .  Additionally, the message 
can be displayed when an old rule is being 
modified, but the old rule is not in the policy
OS 
ERROR: policy x, tmpPolicy x, size x, data 
x x x x x x x x
An issue installing the policy due to a 
possible duplicate hash
OS 
ACL x not found in internal table
Attempting to delete a non-existent ACL
OS 
ACL internal table overflow
Attempting to add an ACL to a full table
OS 
In hapiBroadQosCosQueueConfig, Failed 
to configure minimum bandwidth. Available 
bandwidth x
Attempting to configure the bandwidth 
beyond its capabilities
OS 
USL: failed to put sync response on queue
A response to a sync request was not 
enqueued. This could indicate that a 
previous sync request was received after it 
was timed out  
OS 
USL: failed to sync ipmc table on unit=x
Either the transport failed or the message 
was dropped
OS 
usl_task_ipmc_msg_send(): failed to send 
with x
Either the transport failed or the message 
was dropped
OS 
USL: No available entries in the STG table
The Spanning Tree Group table is full in 
USL
OS 
USL: failed to sync stg table on unit=x
Could not synchronize unit x due to a 
transport failure or API issue on remote 
unit.  A synchronization retry will be issued
OS 
USL: A Trunk doesn't exist in USL
Attempting to modify a Trunk that doesn’t 
exist