Netgear M4100-12G-POE+ (GSM7212P) - 12-Port Managed Gigabit Switch Guide De Logiciel

(NETGEAR Switch) #show interfaces switchport general

Intf

 

     PVID

  

Ingress

 

   Acceptable

  

Untagged

  

Tagged

 

   Forbidden Dynamic

                Filtering

  

Frame 

Type

  

Vlans

 

    Vlans

 

    Vlans

 

    Vlans

--------- ----- ---------- ----------- --------- --------- --------- ---------

1/0/1

 

    1

      Enabled

 

   Admit All

 

  1,4-7

 

    30-40,55

  

3,100-200

 88,96

1/0/2

 

    1

      Disabled

 

  Admit All

 

  1

          30-40,55

  

none

 

     none

This section describes the commands you use to configure double VLAN (DVLAN). Double 
VLAN tagging is a way to pass VLAN traffic from one customer domain to another through a 
Metro Core in a simple and cost effective manner. The additional tag on the traffic helps 
differentiate between customers in the MAN while preserving the VLAN identification of the 
individual customers when they enter their own 802.1Q domain.

This command configures the ether-type for all interfaces. The ether-type may have the 
values of 802.1Q, vman, or custom. If the ether-type has a value of custom, the optional 
value of the custom ether type must be set to a value from 0 to 65535.

This command is used to enable Double VLAN Tunneling on the specified interface.

This command is used to disable Double VLAN Tunneling on the specified interface. By 
default, Double VLAN Tunneling is disabled.

Default

vman

Format

dvlan-tunnel ethertype {802.1Q | vman | custom} [<0-65535>]

Mode

Global Config

Default

disabled

Format

mode dot1q-tunnel

Mode

Interface Config

Format

no mode dot1q-tunnel

Mode

Interface Config