Netgear JR6150 - AC750 WiFi Router - 802.11ac Dual Band Gigabit Manuel D’Utilisation

This section describes tips for troubleshooting some common problems.

Be sure to restart your network in this sequence:

Turn off 

and unplug the modem. 

Turn off the router and computers.

Plug in the modem and turn it on. Wait two minutes.

Turn on the router and wait two minutes.

Turn on the computers.

Make sure that the Ethernet cables are securely plugged in.

The Internet LED on the router is lit when the Ethernet cable connecting the router and the 
modem is plugged in securely and the modem and router are turned on. 

For each powered-on computer connected to the router by an Ethernet cable, the 
corresponding numbered router LAN port LED is lit. 

Make sure that the wireless settings in the computer and router match exactly. 

For a wirelessly connected computer, the wireless network name (SSID) and wireless 
security settings of the router and wireless computer need to match exactly. 

If you set up an access list in the Advanced Wireless Settings screen, you must add each 
wireless computer’s MAC address to the router’s access list.

Make sure that the network settings of the computer are correct.

Wired and wirelessly connected computers need to have network (IP) addresses on the 
same network as the router. The simplest way to set this up is to configure each computer to 
obtain an IP address automatically using DHCP. 

Some cable modem service providers require you to use the MAC address of the computer 
initially registered on the account. You can view the MAC address in the Attached Devices 
screen.