KitchenAid 30-Inch Steam-Assist Combination Microwave Wall Oven, Architect® Series II Utilisation Et Entretien

Replace turntable immediately after cleaning. Do not operate the 
microwave oven without the turntable in place.

■

Mild cleanser and scouring pad

■

Dishwasher

■

Steel-wool pad

■

Dishwasher

To avoid damage to browning pan, do not immerse or rinse with 
water while the browning pan is hot. Do not use steel-wool pads.

■

Warm water, mild detergent and a sponge. Heavily soiled 
areas can be cleaned with a scouring pad and mild cleanser.

■

Dishwasher

■

Dishwasher

■

Dishwasher

■

Dishwasher

■

Has a household fuse blown, or has the circuit breaker  
tripped?
Replace the fuse or reset the circuit breaker. If the problem 
continues, call an electrician.

■

Is the microwave wired properly?
See Installation Instructions.

■

Is the door completely closed?
Firmly close door.

■

Is the electronic oven control set correctly?
See “Microwave Oven Control” section.

■

On some models, is the Control Lock set?
See “Control Lock” section.

■

On combination oven models, is the lower oven self-
cleaning?
The upper oven will not work during the lower oven Self-
Cleaning Cycle.

■

Is the magnetron working properly?
Try to heat 1 cup (250 mL) of cold water for 2 minutes at 
100% cooking power. If water does not heat, call for service. 
See “Assistance or Service” section.

■

This is normal and occurs when the transformer in the 
magnetron cycles on.

■

This is normal and will not affect performance.

■

Is the turntable properly in place?
Make sure turntable is correct side up and is sitting securely 
on the turntable support.

■

Is the turntable support operating properly?
Remove turntable. Remove and clean turntable support and 
rollers. Replace turntable support. Replace turntable. Place 
1 cup (250 mL) of water on the turntable, then restart oven. If 
it still is not working, call for service. See “Assistance or 
Service” section. Do not operate the oven without turntable 
and turntable support working properly.

■

This is normal and depends on motor rotation at beginning of 
cycle.

■

Is the display showing a letter followed by a number?
Clear the display. See “Interactive Touch Display” section. If it 
reappears, call for service. See “Assistance or Service” 
section.

■

Is the Timer in use?
See “Timer” section.

■

Are tones disabled?
See “Sound” section.

■

Some smoke is normal and occurs just as in conventional 
crisping.

■

This is normal and occurs as fat burns off from past cooking. 
Sparking will stop once fat is completely burned off.