Xerox XEScan Solution Guide De Montage

14

XEScan Solution Installation Guide

7.  The first screen is used to set the printer name and connection type. Ensure that you select the correct

interface connection, or output folder. Click the Next button.

8.  Place a checkmark next to all the media the customer wants available for the printer. The media that

are selected represents all the possible media the customer could install in the printer. Click the Next
button.

9.  Use the pull-down menus to enter the settings for the actual media installed in the printer. The settings

must match the media installed media or printing may no take place, or the output will be
unsatisfactory. Click the Next button.

10.  Enter the settings that will serve as the default print job settings. Click the Next button.

11.  Perform the media calibration for (2) of the customers most frequently used media and mode settings:

a)  Place a checkmark next to (2) of the customer’s most frequently used media and mode settings.

The media selected will most likely match the media loaded in the printer.

b)  Click the Print Target button. When a target has finished printing, allow it to sit for 1 hour before

scanning.

c)  Click the Scan Target button. When prompted, insert the target into the scanner and click the OK

button.

d)  When the target has been scanned and the calibration completed, repeat the above step for any

other media targets.

12.  When the calibration phase is complete, click the Finish button. Click the OK button to close the

Hardware dialog, or repeat steps 4-11 to install another printer.