Xerox Phaser 5335 Guide De Montage

54

Using PCL Emulation

The section explains the paper eject function of the printer. 

In the PCL emulation mode, the printer does not eject a job unless it receives a full 
page worth of data. When the host interface is Parallel or USB, and if only a portion 
of a page is received, the printer does not eject the page. The printer waits for the 
data and shows [Data Wait] on the display until the time set under [Time-out] 
elapses.

In such situation, you can forcibly print the page without waiting for the time-out 
period to elapse.

Use the following steps when forcibly ejecting the data remained in the printer.

NOTE: If you send a job to the printer while the display says [Data Wait], the job may not 
be printed successfully. 
Send a job to the printer after forcibly ejecting the current job or after the time-out period 
has elapsed. 

Reference: For information about the [Time-out] feature, refer to the ‘User Guide’.

1.

Press the <OK/Eject> button when the 
display is in the state shown on the right.

The printing starts.

When the printing is finished, the display 
reads [Ready to print].

Important: When [Print Mode] (common menu) is set to [Auto], you cannot force-eject a 
job since the display does not show [Data Wait].

<OK/Eject> button