Xerox Phaser 5335 Mode D'Emploi

190

A Appendix

Additional memory goes into the controller board right underneath a network expansion 

card (optional). If your printer has a network expansion card, remove it to get access to the 

RAM slot. For information on how to remove/reinstall the network expansion card, refer to 

the installation guide provided for the network expansion card.

The following describes how to install additional memory in the printer.
The printer has one slot for installing a memory card. If you want to add memory when the 

slot already has a memory card, replace the memory card with the one with larger capacity.

• This equipment has been designed to restrict operator access to safe areas only. 

Operator access to hazardous areas is restricted with covers or guards, which would 

require a tool to remove. Never remove these covers or guards.

Important
• Before plugging or unplugging the interface cable connector, be sure to switch off the printer or unplug 

the power cord from the power outlet. Plugging or unplugging the connector when the printer is on can 

cause printer failure.

1. Switch the power off by pressing the power 

switch on the front lower right of the printer 

to the <O> position.

Unplug the power cord from the power 

outlet and the printer.

2. Remove the two screws that secure the 

rear cover to the printer.

Network expansion card 

Additional memory