Xerox Phaser 240 Mode D'Emploi
Front and Rear Panels
7
User Manual
7-5
In the following tables,
- indicates that the DIP switch is up or pressed in at
the top, depending on the package style of the DIP switch.
¯ indicates that
the switch is down or pressed in at the bottom.
Phaser 240 rear panel DIP switches
Switch
Function
Switch settings
1
Reset/run
-
: The printer resets and does not accept data
while the switch is in the up position.
¯
: The printer runs a self-test, then proceeds
to run normally. Leave the switch down for
normal operation.
normal operation.
2, 3, and 4
See the next table.
See the next table.
Phaser 240 DIP Switch combinations
Switches
Operation
1
2
3
4
¯
¯
¯
¯
Color corrections disabled*
¯
-
¯
¯
Not Used
¯
¯
-
¯
Color corrections enabled* (factory default)
¯
-
-
¯
For service personnel only
¯
¯
¯
-
Print conÞguration page**
¯
-
¯
-
Sample prints enabled
¯
¯
-
-
For service personnel only
¯
-
-
-
For service personnel only
* The default color correction is Vivid Color. Color correction utility
Þles downloaded to the printer alter this setting. Switch 3 must be in
the up position for downloaded color corrections to take affect.
the up position for downloaded color corrections to take affect.
**To print the conÞguration page, the
READY
indicator must Þrst be on
steady (not blinking). Note current Switch settings, then set
Switches 1, 2, 3, and 4 down. After about 5 seconds, set Switch 4
up to activate the print. After the print, return the DIP switches to
their original positions.
Switches 1, 2, 3, and 4 down. After about 5 seconds, set Switch 4
up to activate the print. After the print, return the DIP switches to
their original positions.