Zanussi ZWF91483W Manuel D’Utilisation

Touch the button 

 .

• The indicator of the button 

 stops to

flash and stays on.

• The programme starts, the door locks, the

indicator 

 is on.

• The drain pump can operate for a short time

at the beginning of the washing cycle.

After approximately 15 minutes from

the start of the programme:

• The appliance adjusts automatically

the programme duration agree with

the laundry load.

• The display shows the new value.

1. Touch the button 

 again and again to

choose the number of hours in which you want

the washing cycle to be finished.

The display shows the number of hours you set
(e.g. 

) and the indicator above the button 

 is

on to show that his option is active.
2. Touch the button 

 :

• The door is locked.

• The appliance starts the countdown.

• When the countdown is completed, the

programme starts automatically.

You can cancel or change the set of

the Finish In option before you touch
the button 

 . After touching the

button 

 you can only cancel the

Finish In option.

To cancel the the Finish In option:

a. Touch the button 

 to set the appliance

to pause. The indicator of button 

flashes.

b. Touch the button 

 until the indicator

above this button goes off.
Touch the button 

 again to start the

programme immediately.

CHANGING THE OPTIONS
You can change only some options before they

operate.

1. Touch 

 .

The indicator of this button flashes.

2. Change the options. If you change any option

the Finish In option (if set) will be disabled.

3. Touch 

 again.

The programme continues.

1. Press the button   for some seconds to

cancel the programme and to deactivate the

appliance.

2. Press the same button again to activate the

appliance. Now, you can set a new washing

programme.

Before starting the new programme

the appliance could drain the water. In

this case, make sure that the detergent

is still in the detergent compartment, if

not fill the detergent again.

While a programme (or the 

) operates, the

appliance door is locked. The indicator 

 is on.

CAUTION! If the temperature and

level of the water in the drum are too

high, you cannot open the door.

1. Touch the button 

 to pause the appliance.

2. Wait until the indicator 

 goes off.

3. You can open the door.
4. Close the door and touch the button 

 again.

The programme (or the 

) continues.

AT THE END OF THE PROGRAMME
• The appliance stops automatically.

• The acoustic signal operates (if it is activated).
• In the display   comes on.
• The indicator of the button 

 goes off.

• The door lock indicator 

 goes off.

• You can open the door.

• Remove the laundry from the appliance. Make

sure that the drum is empty.

• Press the button   for some seconds to

deactivate the appliance.

• Close the water tap.