Cisco Cisco Mobile Wireless Transport Manager 6.1

CSCsz56999

When provisioning IPRAN nodes from the Provision tab of the web interface, some 

provisioning operations might fail on the node with these symptoms and conditions:

None. The user must know the card type information and submit provision requests based 

on the capabilities of the card.

Use this document in conjunction with the following documents:

Creating 76xx Serial 
interface "channel-group 
<x> timeslots <x>"

invalid input detected

When serial interface is created on SPA-24CHT1-CE-ATM SPA. 
This SPA is primarily used to configure Circuit Emulation 
Functions [CESoP and SAToP], but user creates channelized serial 
interfaces in MWTM provision request.

Provisioning ATM 
Framing for 76xx ATM 
interfaces "atm framing 
<x>" 

Invalid input detected

ATM Framing option can be provisioned only on SPA-2XOC3-ATM 
or SPA-4XOC3-ATM SPA, but user sets ATM Framing option on 
SPA-24CHT1-CE-ATM in MWTM provision request. 

Enabling PTP for 2941 
Vlan interfaces "ptp 
enable" option 

Error: local interface 

is down, please make 

sure to turn it on

When configuring PTP, the GigabitEthernet interface port 
associated with the Vlan is not up and user selects this Vlan to 
enable PTP. 

Configuring speed for 2941 
Gigabit Ethernet interfaces 
"speed <x>"

invalid input detected 

at '^' marker

When configuring speed option for GigabitEthernet ports 0 and 1 
and these ports do not support the speed CLI.

Configuring GSM SH for 
1941s, 3825a on 
non-motherboard cards 
"encapsulation gsm-abis"

Error in encaps setup. 

Encapsulation not 

changed

When configuring GSM on Serial interface on non-zero slot number 
as these slots do not support GSM encapsulation.

Configuring multiple 
Serial Interfaces per WIC, 
"channel-group <x> 
timeslots <x>”

Channel-groups per port 

limit exceeded

When configuring more than two Serial controller channels per 
WIC on 1941 or more than four Serials per port on 2941 devices.