Cisco Cisco Web Security Appliance S660 Mode D'Emploi

Connect the Appliance to networks and devices. See 

.

Complete the System Setup Wizard worksheet. See 

If you are setting up a virtual appliance: 

Use the 

loadlicense

 command to load the virtual appliance license. For complete information, 

see the Cisco Content Security Virtual Appliance Installation Guide, available from 

Enable the HTTP and/or HTTPS interfaces: In the command-line interface (CLI), run the 

interfaceconfig

 command. 

In order to set up Web Hybrid mode, it is necessary to run the System Setup Wizard to configure 
the appliance in Standard mode, then upgrade to AsyncOS 9.2, and then re-run the System Setup 
Wizard to configure in Hybrid Web Security mode. (This does not apply to virtual images that are 
not being upgraded.)

For compatibility with Cloud Web Security policies, when operating in Web Hybrid mode at 
least one anti-malware scanning engine (McAfee, Sophos, or Webroot) must be licensed and 
available. Ensure the valid license(s) or feature key(s) are available in order to complete set-up in 
Web Hybrid mode.

Both CWS and WSA require a Certificate Authority-signed certificate to authenticate and secure 
communications between them. You must generate this certificate externally and upload the 
certificate and its key to both Cisco ScanCenter and the Cisco WSA. See 

Register this Web Security appliance with Cisco Cloud Web Security to obtain an authorization 
token. Be aware that this token is valid for one hour; if you have not used it to configure the 
WSA within that time, you will have to generate another. See 

Note that reference information for each configuration item used in the System Setup Wizard is 
available at 

.

Open a browser and enter the IP address of the Web Security appliance. The first time you run the System 
Setup Wizard, use the default IP address:

https://192.168.42.42:8443

 

-or-

http://192.168.42.42:8080

 

where 

192.168.42.42 

is the default IP address, and

 8080 

is the default admin port setting for HTTP, 

and 

8443

 is default admin port for HTTPS.

Otherwise, if the appliance is currently configured, use the IP address of the M1 port.

When the appliance login screen appears, enter the user name and passphrase to access the appliance. 
By default, the appliance ships with the following user name and passphrase: