Cisco Cisco Content Security Management Appliance M1070 Mode D'Emploi

To verify that the 

publishconfig 

command was successful, check the 

smad_logs

 file. You can also 

verify that the publish history was successful from the Security Management appliance GUI by choosing 
Web > Utilities > Web Appliance Status. From this page choose the web appliance that you want the 
publish history details. Additionally, you can go the Publish History page: Web > Utilities > Publish > 
Publish History.

Outside of the CLI, ensure that you are able to access the 

configuration

 directory of the appliance. See 

 for more information. 

Place an entire configuration file or subsection of a configuration file in the 

configuration

 directory of 

the appliance, or edit an existing configuration that was created from the 

saveconfig

 command. 

Within the CLI, use the 

loadconfig

 command to load the configuration file you placed in the directory 

from Step 2, or paste the text (XML syntax) directly into the CLI. 

In this example, a file named 

changed.config.xml

 is uploaded and the changes are committed: 

mail3.example.com> loadconfig

1. Paste via CLI

2. Load from file

[1]> 2

Enter the name of the file to import:

[]> changed.config.xml

Values have been loaded.

Be sure to run "commit" to make these settings active.

mail3.example.com> commit

In this example, a new configuration file is pasted directly at the command line. (Remember to press 
Ctrl-D on a blank line to end the paste command.) Then the System Setup Wizard is used to change the 
default hostname, IP address, and gateway information. (For more information, see 

.) Finally, the changes are committed. 

mail3.example.com> loadconfig

1. Paste via CLI

2. Load from file

[1]> 1

Paste the configuration file now. Press CTRL-D on a blank line when done.

[The configuration file is pasted until the end tag </config>. Control-D is entered on a 

Values have been loaded.

Be sure to run "commit" to make these settings active.

mail3.example.com> commit

Please enter some comments describing your changes:

[]> pasted new configuration file and changed default settings