Cisco Cisco NSS030 Smart Storage External Power Adapter Manuel De Maintenance

Verifying the Hardware Installation

Cisco Small Business NSS300 Series Smart Storage Administration Guide

24

 

Plug the other end of the power cord into a battery-backed-up outlet on the UPS, 
or a standard power outlet if a UPS is not being used.

To start the NAS, press and release the Power button on the front panel.

Listen for one beep. Wait for one to two minutes until the device beeps another 
time.

The device has started successfully. The power light turns solid green when the 
NAS is ready to use.

To verify the hardware installation, complete the following tasks:

•

Check the cable connections.

•

Check the indicator lights, as described in 

If you encounter problems, consider the following tips:

•

If the NAS does not recognize the disk drives, possible causes and 
solutions are:

-

Confirm that the disk drive is supported by Cisco. See the Cisco 
approved vendor list at 

-

Disk tray is installed incorrectly. Try removing and reseating the disk tray.

-

Power the device off, then back on to recognize the disk drives.

If you need help resolving a problem, visit the Cisco Small Business Support 
Community at 

. For technical documentation 

and other links, see 

.

Before you begin the system configuration, make sure that you have a computer 
that meets the following requirements: