Cisco Cisco 1 GHz GainMaker Amplifier Guide De Montage
Chapter 2 Installation and Configuration
Signal Flow from Right to Left
Note: Coax In may be switched with the Coax Out if you reverse the amplifier
module and feed the signal from right to left.
5 Using a ½-inch torque wrench, tighten the strand clamp bolts from 5 ft-lb to 8 ft-lb
(6.8 Nm to 10.8 Nm). Make sure there is good mechanical contact between the
strand and the housing.
Note: A slight tilt of the face of the housing is normal. Cable tension will cause the
Note: A slight tilt of the face of the housing is normal. Cable tension will cause the
housing to hang more closely to vertical.
6 Connect the coaxial cable to the pin connector according to connector
manufacturer specifications.
7 Proceed to
Installing Accessories (on page 32).
To Install the Housing in a Pedestal
Complete the following steps to install the node in a pedestal.
1 Remove the cover of the pedestal.
2 Remove the self-tapping bolts from the strand clamps and set the bolts and strand
1 Remove the cover of the pedestal.
2 Remove the self-tapping bolts from the strand clamps and set the bolts and strand
clamps aside.
30
OL-31156-01